Table and Post Mounted Abrasive Cut-Off Machine

The TMCAFT Post Mounted Hydraulic Cut-Off’s provide remote control of the wheel head with a pressure capability of up to 400 lbs. The controlled Hydraulic pressure enables the machine to cut up to 5 times faster than a manual operation, the even pressure enables greater wheel life and cooler cutting. The Gondola Air Float unit allows accurate positioning of the work under the abrasive disk with a vivid laser line at the cut point. When the work is in position a vacuum holds the gondola whilst the cut is made. 

Model 800/132/4 Dry Abrasive Cut off System. 132kW drive motor, Hydraulically powered 360 degree Rotating table with index points at 90' and 180' 900 mm cross travel movement with 560 mm fore & aft movement. The abrasive wheel is recessed into a powered wheel guard during casting loading and unloading.

The twin station enables the operator to prepare work on the second table whilst the first table is engaged in cutting. Thereby improving productivity.

Abrasive wheel size up to 760 mm flat  75 kW drive

This cutting machine has a cross traverse facility and enclosure. 

30 kW drive. Wheel diameter 760 mm 

General purpose cutting. The cutting head approaches from the rear, manual control with power assistance, The table traverses across (manual control). The castings can be cut with location fixtures only (clamping not required)

Abrasive wheel size up to 508 mm flat & depressed centre, 22kW drive

For the removal of runners & risers from high value castings where a dry cutting system would have generated heat cracks. laser alignment of work to wheel.

Abrasive wheel size up to 760  mm flat & depressed centre, 75 kW drive

Other machine sizes and combinations are available